I use the FormLabs Form 2 SLA 3D printer quite often. Once the parts are finished printing they need to be cured using ultraviolet light. This process fully solidifies the prints so they aren’t sticky from the resin. I built an enclosure for our design studio, tool. Inc. with only a few parts ordered online and laser cut birch plywood. Have a look!
Heres what you’ll need to make your own:
1. 1/2” birch ply
UV Filtering Acrylic sheet and LED lamp
- (1) 12″ x 24″ fluorescent orange UV resistant acrylic sheet ($14.75 per sheet)
- (3) 110v 20w 395-405nm UV LED lights ($42.99 per light)
- Mortise-Mount Hinge with Nonstandard Hole Pattern Non-removable Pin, Square, Zinc-Plated Steel, 1″ x 1/2″ Door Leaf
- 2 Magnets for the door (2 steel screws with spacers do the trick on the panel side)
- 7 Nylon Unthreaded spacers – 1/2in OD 3/8 length
- 1 1/4 inch Steel flathead wood screws
Finally some sweet flat pattern design files that I’ll flow your way just shoot me an email.